AP 330mm 4Pots to 308mm
#1
About to replace my discs - worn out
Is it possible to convet this kit to 308mm (new brackets etc) so I can run the car on 16". I have a set of 17" x 7.5 wheels with a 38mm offset for my 22B is there a tyre size I can fit to fit these to a classic.
Is it possible to convet this kit to 308mm (new brackets etc) so I can run the car on 16". I have a set of 17" x 7.5 wheels with a 38mm offset for my 22B is there a tyre size I can fit to fit these to a classic.
#2
Just had a look at the AP-Racing website (www.apracing.com) the same CP5200 calipers are used for the 330 and 304 kits so I would think that you would just need different mounting brackets.
Try mailing AP Racing and see whether they sell the brackets separately or speak to GodSpeed or HiSpec as I'm sure one of them could do a bracket for you!
Try mailing AP Racing and see whether they sell the brackets separately or speak to GodSpeed or HiSpec as I'm sure one of them could do a bracket for you!
#3
Moderator
iTrader: (1)
Remember that the 308mm kit uses different pads from the 330mm kit, despite the caliper being the same - it's to allow more clearance to the bell with the discs being smaller. It's only an issue once the pads are down to their last few mm of material though.
All you should need are the new mounting brackets, and all should fit.
John
All you should need are the new mounting brackets, and all should fit.
John
Thread
Thread Starter
Forum
Replies
Last Post
TonyBurns
Wheels, Tyres & Brakes
2
26 October 2001 12:04 PM