Notices
Wheels, Tyres & Brakes

ABS light Comes On Help!!

Thread Tools
 
Search this Thread
 
Old 19 February 2004 | 10:24 AM
  #1  
DBMSCOOBY99's Avatar
DBMSCOOBY99
Thread Starter
Scooby Regular
 
Joined: Apr 2003
Posts: 336
Likes: 0
Question ABS light Comes On Help!!

Hi Everybody

I'm having a bit of a problem with my ABS on my 99 turbo

I get the ABS dash light come on after about 5 miles of driving. It happened on the way home from work last night and also on the way to work this morning. I tested the brakes today before the ABS light came on and the ABS worked fine and also the light didn't come on straight after the emergency stop. After the ABS light has come on no ABS.

I have read on a tread ages ago about dirty ABS sensors on the hubs that some time's causes a problem. Does this sound like it could be this or is it something more serious? Also will I get a CEL read out, so I can find out more about the fault?

Any help would be much appreciated

Thanks

Tom
Old 19 February 2004 | 10:27 AM
  #2  
Godspeed Brakes's Avatar
Godspeed Brakes
THE braking specialist
iTrader: (259)
 
Joined: Dec 2000
Posts: 8,010
Likes: 50
From: www.godspeedbrakes.co.uk
Default

it could be a bit of muck on the sensors or they could be faulty , or it could be the fluid has dropped as the pads are wearing down so the sensor has detected low fluid , check your reservoir.
Cheers Ian
Old 19 February 2004 | 11:39 AM
  #3  
DBMSCOOBY99's Avatar
DBMSCOOBY99
Thread Starter
Scooby Regular
 
Joined: Apr 2003
Posts: 336
Likes: 0
Thumbs up

Thanks for the advise Ian

Just been out to have a look at the brake fluid level that's all ok. I had the ABS light come on about 4 months ago, That is when I saw that tread about dirty sensors, so I had a look at the sensors when I was having my tyres change (just happened to be on the same day). I didn't manage to get them fee as I was only using my hands to try and undo them. But the light didn't show up again until now.

Do you know how easy it is to get the sensors off the car (any special tool needed) and are they easy to clean?

Oh and if it is a faulty sensor how can I tell which one it is?

Any more help would be great.

Thanks

Last edited by DBMSCOOBY99; 19 February 2004 at 11:43 AM.
Old 19 February 2004 | 11:47 AM
  #4  
Godspeed Brakes's Avatar
Godspeed Brakes
THE braking specialist
iTrader: (259)
 
Joined: Dec 2000
Posts: 8,010
Likes: 50
From: www.godspeedbrakes.co.uk
Default

Its one bolt holding them in place , there are 2 types , one that fits in a hole and points at a metal ring on the back of the drive flange , the other type fits into a hole in the hub and senses off the CV joints , these dont generally have a dirt problem as they are sealed and road muck cant get in , the other type does get dirty
They may need a bit of a tug to get them out as the hubs do go rusty , just be carefull not to go too rough with them or you could damage them

Take your time and it should be easy enough

Cheers Ian
Old 19 February 2004 | 11:52 AM
  #5  
R Johnson's Avatar
R Johnson
Scooby Newbie
 
Joined: Feb 2004
Posts: 18
Likes: 0
Default

my abs light has been on for the last 2 weeks ,fixed it last night ,both brake light bulbs had blown! I didnt think blown bulbs would cause the abs to shut down,but it does.Its worth checking, mines a MY95
Old 19 February 2004 | 12:50 PM
  #6  
DBMSCOOBY99's Avatar
DBMSCOOBY99
Thread Starter
Scooby Regular
 
Joined: Apr 2003
Posts: 336
Likes: 0
Unhappy

Thanks again Ian And R Johnson

I wish it was as easy as the brake bulbs. That would have been a nice easy fix but they are all ok

Ian :

I have got a feeling that I have got the sealed units that fit into a hole @ the back of the hubs the cars is a MY99.

Do you know if the ECU Tec's delta dash would display the fault codes as it seem the only way to find out exactly where the fault is on the ABS system, I.E which sensor has gone up the spout if it is a sensor @ fault.

God I hate it when something's goes wrong with the scoob, usually means its about to fleece my pockets

Thanks

Tom
Old 14 April 2004 | 07:31 PM
  #7  
RRE's Avatar
RRE
Scooby Regular
 
Joined: Apr 2003
Posts: 358
Likes: 0
From: Copenhagen
Default

Did you ever manage to solve the problem? I have simular problem on my 99 GT. The Subaru testing software tells me error 53, but nobody can tell me what that means :-(

Rasmus
Old 02 May 2004 | 01:00 PM
  #8  
Simmo2's Avatar
Simmo2
Scooby Regular
 
Joined: Aug 2002
Posts: 279
Likes: 0
Talking

Originally Posted by R Johnson
my abs light has been on for the last 2 weeks ,fixed it last night ,both brake light bulbs had blown! I didnt think blown bulbs would cause the abs to shut down,but it does.Its worth checking, mines a MY95

Excellent shout had just the same happen to me you certainly saved me a garage visit.

Many Thanks

Pete
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
KAS35RSTI
Subaru
27
04 November 2021 08:12 PM
Pro-Line Motorsport
Car Parts For Sale
48
21 July 2017 10:50 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
29 December 2015 12:07 AM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 08:03 AM
Ganz1983
Subaru
5
02 October 2015 10:22 AM




All times are GMT +1. The time now is 05:17 PM.