9.5 rota drift on blobeye
#1
Scooby Regular
Thread Starter
iTrader: (3)
Join Date: Jun 2012
Location: highlands
Posts: 110
Likes: 0
Received 0 Likes
on
0 Posts
9.5 rota drift on blobeye
hey guys,
realy want a set of 18x9.5 et38 rota grid drifts for my blobeye sti, i know i will need a 3mm spacer to clear my brembos, most seem to run 245 tyres, i have 4 nearly new 225 lying around, will they give to much stretch?
my rear question is about arch rolling, i have coilovers and camber adjust top mounts but most say you need some rolling, if you roll the arch on the rear does it just roll the under lip or does it roll the whole lower half of arch, would this not make the arch stick out a little further than the bumper were the rear bumper mounts?
if anyone has photos of there rolled arch then that would help
cheers
James
realy want a set of 18x9.5 et38 rota grid drifts for my blobeye sti, i know i will need a 3mm spacer to clear my brembos, most seem to run 245 tyres, i have 4 nearly new 225 lying around, will they give to much stretch?
my rear question is about arch rolling, i have coilovers and camber adjust top mounts but most say you need some rolling, if you roll the arch on the rear does it just roll the under lip or does it roll the whole lower half of arch, would this not make the arch stick out a little further than the bumper were the rear bumper mounts?
if anyone has photos of there rolled arch then that would help
cheers
James
#2
Former Sponsor
iTrader: (72)
they will fit fine with 225,40,18s ,they will be steretched and I would advise an arch roll on the rears , it will just roll the lip up under the arch unles you want it flared which will pull it out abit , rolled arches don't look any different than normal arched tbh you wont nothic it
mags
mags
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM